-- Your Gateway should blink red in groups of 4. Click here if that is not the case.
-- Enter the 8-Digit Serial number on the back of the gateway below and press the "Submit" button. This may take up to 30 seconds to find device.
-- Within about 10 seconds the sensor should have a temp on it. If not try again, if so, click the button below.
Your Sensor was registered and named __name__!
Before continuing, ensure your Professional Weather Station (PWS) is fully set up according to the instructions provided with the weather station (also available online: Setup Instructions (pdf)).
To get the PWS Display to talk with the gateway:
On the PWS Display, press and hold the "▼/Rain" button until you hear a beep.
Ensure the PWS Display is at least 5 feet away from the gateway and
Press (and release) the grey button on the gateway
The PWS Display will search for the gateway. On the lower left of the weather station display, just above the time and date, the "REG" indicator will begin to flash. When the device has completed registration: The device will beep ONLY ONCE! (Two rapid beeps? See below). The "REG" indicator will no longer flash (stays on solid) then finally the "INTERNET" indicator will appear to the right of the "REG" indicator.IMPORTANT INFORMATION REGARDING WEATHER STATIONS
